id be down if it was either earlier or later july, out of country for the middle bit lol

Me, calabrej, and philosophydaddy will be there for green.  Lookin forward to it.

so what you are shimming is the hop up arm, so that it applies the hop in the same place consistently.  I cut a piece of plastic and punched a whole in it so that when i put the hop up arm in i can also put the shim in as well and it will be held in place, people use brass, cut aluminum, and also tinfoil doesn't have to be anything fancy.  If your buying parts then I would recommend brillarmory.com and clandestineairsoft.com  they give good descriptions and have a little tighter quality control on what they send out.  Also, brill armory ships super quick which is nice. I personally just use teflon tape to seal my bucking but extra compression is never a bad thing.

man this has been a popular topic as of late, someone posted about it on the AA facebook page as well lol.  To make your gun a DMR you really wont need crazy FPS or anything, the most important thing will be consistency.  Two guns may be able to fling bbs the same distance but the one that can do it with tight groupings will be more effective.  To that end, you can do a lot of little mods to help with your consistency.  Stabilize the barrel, seal your bucking to the barrel, shim the hop up arm, glue you air nozzle in place, sealing your cylinder head, and correcting your AOE (angle of engagment) will all go a long way towards making your gun much more consistent, plus with the improved airseal your fps should go up by a bit and stay more consistent between shots.  Also, I would recommend either doing a flat hop or an r hop as they both give more consistent contact and spin to the bbs.  If you just want a normal bucking then I would recommend the maple leaf 70 degree, the ribs really help with its seal.  Other than that, trigger response is your friend since you should only be shooting semi, a lipo a good high torque motor will do you well here.  (High speed gear set will also help improve trigger response.)  Thats about all I can think of off the top of my head but let me know if you have any questions.

Thanks for hosting the game, it was tons of fun!  Only wish that half of green didnt leave after the first game.....lol

Also a huge thank you to all the people that took and posted pictures, there are a lot of good ones this time around!

wish i shot them RS lol

so my normal (currently only) platform is a DMR but I use the mosfet to lock it in semi,  the rules for this OP says that I will need an actual physical lockout, I was wondering if anybody can point me to a guide as to how to accomplish that or could give me any advice? I appreciate it, dont really wanna switch out my spring lol

Lol well me and several of my friends are going then as well, are you going in the morning or the afternoon?