Airsoft Hardware > Gas Powered Guns
Polarstar low air consumption setup. What am I missing?
Ivan:
So I have my p* sitting like this.
Red nozzle
.35 poppet shims in stock poppet
80-90 PSI
AK inner brass barrel
Still shooting 380 with .32
Is my inner barrel too long or should I get a gold low flow poppet?
Dayton:
Get a tight bore barrel and rhop.
A standard hop up nub has to pinch the bb really hard, and hold onto it for quite a while, causing wasted air to go right past the bb for a bit.
Same thing with your barrel, if the bb is loose, air goes right by it, wasting quite a bit. Pick up a Prometheus 6.03
What is your idea of low air consumption? What tank are you using and how many shots are you getting out of it?
ravensquad:
Why would you be shooting 380 with .32's? That's way too hot for fair play if it's not a DMR...
Dayton:
--- Quote from: ravensquad on April 15, 2015, 10:51:14 AM ---Why would you be shooting 380 with .32's? That's way too hot for fair play if it's not a DMR...
--- End quote ---
Oh ya, that too. :)
Ivan:
LOL! I don't want to be shooting 380 with a .32
I chronoed that number before I replaced the 6.01 barrel with a stock brass 6.05+ m4 length and have to recheck chrono.
I am using a 4500/90 tank with an AKA SST reg.
My goal is to use 80-90 psi to be in the 400 fps field range limit with a .20. I was under the impression if I used a red nozzle and shimmed my poppet I could achieve that.
Navigation
[0] Message Index
[#] Next page
Go to full version