I currently came into possession of this rifle and am looking forward to upgrading it to the fullest potential. At the moment I have on my list of parts to purchase include the following
1x B↑Premier Palsonite Cylinder SET VC
-B↑Premier Palsonite Cylinder
-B↑Taper Cylinder Head
-B↑VC Piston
-B↑Spring Guide for VC Piston
http://www.x-fire.org/vsr_bup/e.bup_cylinder_vc_pal.html1x Bore Up trigger set
http://www.x-fire.org/vsr_bup/e.bup_triggerset.html1x 6.01mm PDI tight bore barrel
http://www.x-fire.org/etop/01.html1x Firefly Hop Up Bucking for VSR-10 (Hard)
http://www.airsoftatlanta.com/Firefly_Hop_Up_Bucking_for_VSR_10_Hard_also_fit_p/63320.htmFrom my understanding I need a different spring than the normal upgraded spring that would go with a VSR-10. I didn't have much luck unfortunately in finding anything on my own the last few days of looking through evike.com/airsoftgi.com/and trinityairsoft.com
I also did not find a bolt handle (saw a post on another site that it snapped while the shooter was cocking the gun but there were other reasons other than the resistance of the spring that caused it). I'm wanting this rifle to shoot decently far and be around 515fps with a .25g, but from what I understand I could have a higher spring with more hop up on the pellets to get better accuracy/range and keep it in that fps if few posts regarding the matter that I've read on here are correct.
I'm looking for any suggestions and would very much like the assistance on locating parts if it is not to much trouble.
Thanks again,
Hawkeye
Edit: found an aftermarket Hop Up finally