Author Topic: Marushin Ruger NBB  (Read 1002 times)

Offline TheRev

  • Trade Count: (0)
  • Sergeant
  • *****
  • Posts: 127
    • View Profile
Marushin Ruger NBB
« on: September 04, 2002, 03:35:38 PM »
Ok guys...
I'm not sure if Kyle or Riggs owns the Ruger Mk1 NBB from Marushin (or maybe it's neither of you two), but I have a question. I recently purchased the "stainless" version of the Assassin model (with the integral suppressor). Apparently the one and only magazine I have for this baby burst a seal yesterday. In otherwords, when I try to gas it up, it immediately blows out the top. It's not a slow leak, but the moment I try to put some gas in, it comes right out (like there's no seal at all). I want to take it apart to fix it but I'm a little concerned about small springs and such. Any helpful suggestions?

TheRev

By the way, when I first got the gun, it worked fine. It's a powerful little cuss. Punched a hole through two pop cans sitting back to back.
I was told I could load green gas (hFC22) in it. Instead, I mixed part green with part 134A.

"I like to go to faraway lands, rich in ancient culture, and meet interesting and unique people who speak strange languages, and kill them"
« Last Edit: December 31, 1969, 05:00:00 PM by TheRev »
No plan, no matter how well conceived, survives first contact - Murphy\'s Law 124

Books, my young Padawan, are the food of the mind - Me