Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - chivaman

Pages: [1]
1
AEG's /
« on: July 05, 2005, 10:09:31 PM »
If you want to upgrade your next aeg at any point you should stick to tokyo marui but if you are going to leave it stock go classic army. Member you get what you pay for why do you think that you get more gun for 60 buck more w/ classic army. TM are the best aeg's to work with.

2
Introduce Yourself! /
« on: July 05, 2005, 10:05:06 PM »
well i hope they are better than the JT stores in LA because all the JT stores in LA prety much suck. well that sound like i will be able to feel right at home out there.

3
Introduce Yourself! / Moving to arizona in a month.
« on: July 04, 2005, 10:13:22 PM »
I am moving to chanler arizona in about a month. i have played airsoft for a bout 2 years and i have quite a obsetion with airsoft and i want to know that if i move out to arizona i will be able to satisfy the thirst i have for airsoft.know i am looking for airsoft info. I want to know what kinds of fields are in the pheonix area. How many? How many airsoft stores aside from JungleToys. Are there any indoor field. So forth and so on. Thank You.

4
Troubleshooting /
« on: July 02, 2005, 11:14:58 PM »
First off the ics and tm mp5 are similar but not the same. any one who has worked with a tm and any other airsoft gun knows that tm are the best guns to upgrade if you are a begginer. it sounds like you did not pull back the anti reverse latch and the shimming is all wrong. like reaver said one should learn to take care of ones gun. you should first find out what shimming works with your gun. to do this you might want to take the spring out and put in your gears and shim them in diffrent sets and spin them with out a spring and if they move alot adjust the shimming if they move a little then there are good. and make sure that you pull the anti reverse latch all back because if its forward i will cause your gun to jam. good luck and try. TM's are the best aeg'sto learn with.

5
AEG's /
« on: June 25, 2005, 11:08:11 PM »
nice i like the crane stock

6
AEG's /
« on: June 25, 2005, 11:05:37 PM »
put it on .9 unless it has a mah higher than 3300. other wise stick to .9; what it means it that it will feed 900 mah in one hour (while alowing time to cool down). if you put 1.8 you will be doubleling the mah which will not give your battery enough time to cool down and it can damage your battery.

7
AEG's /
« on: June 25, 2005, 11:02:05 PM »
nice all you need now is a launcher or tac lite.

8
AEG's /
« on: June 25, 2005, 10:59:44 PM »
chage the berral its easy and it make your shots more accurate.

9
Troubleshooting /
« on: June 25, 2005, 10:55:19 PM »
classic army guns can hold a m120 easily but i heard of it handeling a m130 for a term of 3 months during normal use. was the shimming done right? have you checked the tamiya  connectors they have been know to be bad (i suggest going to all dean plungs on your guns).

10
Troubleshooting /
« on: June 25, 2005, 10:47:40 PM »
well springer are great but if you have ever shot the classic army m15 springer you will fall in love with springer all over again. If you need a springer and have 150 bucks to blow its a awsome gun.

11
Troubleshooting /
« on: June 25, 2005, 10:33:20 PM »
it sounds like you took apart the selector switch (which oyu should not have) but make sure when you replace the lower reciver it fits easy not forced (and keep it on safety) because it will mess up you selector switch on the gear box but try taking the screw off the body switch to a new posittion.

12
Troubleshooting /
« on: June 25, 2005, 10:27:06 PM »
the problem is most likely with the spring guide it locks it self and creates a double feed; what you need to do is reposition it in to fit properly. if not the hammer set is f'ed up in which case buy anonter gun.

13
AEG's / its ok but some upgrades needed
« on: June 25, 2005, 10:21:44 PM »
If you like to lug around a heavy guns its great (i do so it ok) the only problem is some time you have to change the bucking because of a double feed problem and it is a bit loud. I would recomend the s-system from marui it feels great shoot great has the eg 1000 motor and looks friggin cool.

Pages: [1]