g36c help

[headhunter]

okay AA, you're my last hope for this.
  I have been trying to put a longer inner barrel in my gun and then put a suppressor over it but I can't get the barrel assembly to come out. I have searched this on Google and youtube-no help. I have disconnected the magwell and removed the three screws as mentioned in other videos but no luck. Also, i cannot figure out how to get the shitty plastic flash hider off. I remember there was a thred a few months back asking that same question but couldn't find it. i have tried heating it with a lighter and cutting it and now i have resorted to sanding it down. please help me.

  dropping link in 3...2...1 http://www.airsoftmegastore.com/1933-JG608-6-HMC-400-FPS-JG-Full-Metal-Gearbox-R36-HMC-Hybrid-Modular-Carbine-Tactical-AEG-Rifle-MK36.aspx

[Old Dog]

Have you tried this site,

MY BAD that site won't work

[xgecko54]

Exactly what's preventing the barrel assembly to come out? My friend had one of those guns, and he got it out just fine.

As for the flash hider, I heard boiling it in water works super well, to dissolve the glue.

[Bob Z Moose]

I say, I say, it's pins, my boy.

http://m.youtube.com/watch?v=OIkvH_InQYI

[CoyDog8]

Ive always just burned my flash hiders off.  Little bit of lighter fluid on the end and let me burn for about a minute or so and bam should be able to get the last little bit off with a pliers.